Showing results: 16 - 30 of 115 items found.
-
PCCextend 135 -
Sycard Technology
The PCCextend 135 allows a CardBus card under test to be powered from an external power supply. MOSFET switches automatically switch the external power to the CardBus card under test when the socket power is applied. The PCCextend 135 provides separate switches for VCC, VPP1 and VPP2. Fabricated on a six-layer board, the PCCextend 135 is designed to minimize signal degradation in the 33MHz CardBus environment.
-
SKU-013-0X -
Amfeltec Corp.
The PCI-to-PMC Extender was designed to convert any standard PCI slot of a PC to a PMC (PCI Mezzanine Card) slot. It allows a standard personal computer to be used as a testing/development platform for PMC interface cards. The adapter allows easy access to the PCI (PMC) logic signals, overcurrent protection and hot-swap capability.
-
IP-Debug-Bus -
Dynamic Engineering
IP-Debug-Bus is a specialized extender card which is optimized for testing IP Modules. The bus signals are all accessible via test points. The testpoints include multiple ground locations and .025 sq. posts for ease of connection to your logic analyzer or scope. The testpoints are labeled for easy identification
-
PCI EmbeddedComputer Systems
This adapter can be used to run, test or program a 3U VPX card in a standard PC PCIe slot. SSC switchable (ON/OFF) PCs available from PCI-Systems Inc.
-
PCCextend 50 -
Sycard Technology
In a high volume production environment a PCCtest socket tester may see several thousand insertion/removal cycles a month. To prevent wear and tear on the PCCtest's 68-pin connector, Sycard supplies a low cost "socket saver", the PCCextend 50. The PCCextend 50 is inserted between the 16-bit PC Card socket and the PCCtest unit.
-
CF extend 162 -
Sycard Technology
In a high volume production environment a CF test 220 socket tester may see several thousand insertion/removal cycles a month. To prevent wear and tear on the CF test 220's 50-pin connector, Sycard supplies a low-cost socket saver, the CFextend 162. The CF extend 162 is inserted between the CompactFlash™ socket and the CF test 220 unit.
-
CF extend 182 -
Sycard Technology
The CF extend 182 is a low profile flexible extender card designed to physically extend the CompactFlash™ socket for easy access. Similar to Sycard's CF extend 180, the model 182 reduces the overall dimensions of the extender by using a single piece flexible circuit board. The lower profile allows for uses in many applications where the CF extend 180 was too bulky. The CF extend 182 extends the CompactFlash socket 5".
-
-
PXIe 3U 8 Slot -
Kontron
PXI (PCI eXtensions for Instrumentation) is a PC-based bus platform for measurement and automation systems. PXI uses commercial PC-based PCI bus technology while combining rugged CompactPCI modular packaging, as well as key timing and synchronization features. While derived from cPCI, PXI adds the timing and synchronization features, among other things, that were not present in cPCI.
-
PXI 3U -
Kontron
PXI (PCI eXtensions for Instrumentation) is a PC-based bus platform for measurement and automation systems. PXI uses commercial PC-based PCI bus technology while combining rugged CompactPCI modular packaging, as well as key timing and synchronization features. While derived from cPCI, PXI adds the timing and synchronization features, among other things, that were not present in cPCI.
-
CPCI-SIP-2 -
ALPHI Technology Corporation
The CPCI-SIP is a 3U format CompactPCI (CPCI) bus IP carrier. The CPCI-SIP-2 provides mechanical support and the electrical interfaces for two single width IP modules, or a double width IP module. Multiple CPCI-SIP-2 boards may be installed in a single system.
-
3690-34 -
VECTOR Electronics and Technology, Inc.
3.3V or 5V PCI Extender card uses universal pattern for 32/64 bits in the short card size. Extender is design for use in developing and troubleshooting of PCI local bus 32 and 64 bits cards.
-
8100 -
ELMA Electronic, Inc.
The metering PMC to PMC extender is a comprehensive development tool for use with PMC cards on a VMEbus, Compact PCI, or other carrier card.
-
CF2PCE -
TEAM SOLUTIONS, INC.
The CF2PCE extender board allows PCMCIA cards to be used in Compact Flash Type I or II slots. Typically this extender is for use in a development or production environment. The extender routes all 50 CF signals via pin-headers for DSO or Logic Analyzer connection.
-
VECTOR Electronics and Technology, Inc.
Extender boards are designed to bring a circuit card completely out of a card cage or enclosure so that it can be tested or debugged. This provides access to both sides of the test board.